MUGI EVO
MUGI EVO TEA RACER TUTORIALS MULTIMEDIA INFO

Evo Construction - Servo Fitting

Strap down the servos
STRAP DOWN THE SERVOS
Add the Servos

Place your servos on the wing so that the cable ties will grip the servo just below their mounting lugs, as shown. A drop of glue or a piece of double sided tape under each servo will ensure that they will never slip out of their mounts.

Tighten the cable ties down around the servos as practically tight as you can manage. The free ends of the ties should be left free, not cut off.

Locating the cable tie holes

For a guide to where to make holes for your cable ties, either place the servo so that the horn lies on the servo line (see "Plans"), or follow these instructions:

Measure 150mm back from the nose of the sheet and then measure 60mm out either side of the centreline - make small holes here

Measure 170mm back from the nose of the sheet and then measure 70mm out either side of the centreline - make small holes here.

You now have holes through which to put the cable ties that put the servos in the correct alignment - presuming you're using ball-joint connectors at the elevons.

Copyright© 2013 www.mugi.co.uk